Simple and Easy to Use for ROV The module Boards provide a high-speed, long-distance Ethernet connection to an ROV or other remote platform. Designed for use with a twisted pair of wires or single wire. Module provide a Ethernet and a powerline prot. Convenient Wiring Connect two or one wires between each module L to L, N to N. Doesn't have to be two wire, only L/N to LN one wire works fine. It is not must connect L and N wires with power. Even only cable no power through, also can communication well. If need long-distance power supply, Power through L and N can deliver power and ethernet at the same time. Power each board with a 12V input to the small terminal block, Connect an Ethernet cable and the connection should become active immediately. Wide Range of Uses This module can be a part of the ROV electronics Package and works well in conjunction with the Raspberry Pi, Pixhawk, and ArduSub Control Software, brings convenience to long-distance power transmission and long-distance cable communication. It is a good choice for underwater robot cable communication. Specification Table Supply Voltage: DC - 12V - 200mA ( min 10 - max 13 ) Max Practical Bandwidth: 80 Mbps Physical Layer Bandwidth: 200 Mbps Working Frequency: 2 - 30 MHz Tether Length: > 500 m Operating Temperature: 0°C to +70°C Storage Temperature: -20°C to +70°C Tether Wire Gauge: 12 AWG - 30 AWG Power Wire Gauge: 16 AWG - 26 AWG Dimensions: 64 x 46 mm Screw Hole Spacing: 34 x 32 mm Main Board Dimensions: 38 x 38 x 15 mm (LxWxH) Main Board Weight: 20 g Powerline Voltage: 90v - 240v ( DC 360v tested ) Powerline Connection: One wire recommended when power through wires Module Weight: 27.5g Each Kit Contents: Module with Main Board x 2
Trustpilot
1 month ago
2 weeks ago
