Trend Tool, Blade & Bit Cleaner, CLEAN/500

Used this on my hedge trimmer,.which was loaded with resin from last year. It's better value for money than some other sprays. It has a fine atomiser spray which avoids wasting the product. Sprayed on the blade and agitated with a brush the blade was left in almost new condition. Recommend this stuff.

Excellent product. Used on hedge-cutter whilst cutting 150 m of hedge. Lubricates and cleans blades very effectively.

Very good cleaner, however blades were still brown, so perhaps need to leave on for longer then scrub with a brush. Good value item, much cheaper than other brands. Should last a couple of years.

I'm glad I brought this resin remover. I spent a morning cleaning all of my circular saw blades & they all came up gleaming & are cutting as well as the day I brought them. It's not miracle juice, & you will need to remove excess resin where it is really thickly caked on but it does a great job of lifting off the stuff stuck on the cutting edges. I just used a toothbrush & some elbow grease. I'm not sure if I could have got the same results with some homemade concoction but for £8, I'll get plenty of cleans out of this bottle, as you don't need to spray on a massive amount.

Great stuff bought to clean residue off an hedge trimmer and it works a treat. Good value as it is cheaper than proprietary brands such as Dewalt also contains more fluid, give it a go would recommend.

Great product. Super job on table saw & track saw blades & all router bits. Came up like new.

Awesome stuff. Plus 10 times cheaper than what I used to use!

Good general tool cleaner

This product really cleans tools and tool accessories properly and with ease .

Cumple, no hace milagros, pero se nota.

I've been using this for a while, seems to work well even with heavily used blades that need cleaning in the worst way. Spray it on, let it soak for a few minutes, use a brass bristle brush and the resin and pitch just washes away. I use it in a small pan where I can use some water to rinse my blades and bits, seems to work very quickly and is one of the easiest cleaners I've used. I know that I would rather clean my blades along instead of sharpening, I use to think they were dull, now I know they've been in need of a good cleaning. The product goes a long way, I've cleaned over a dozen blades and still have lots of product left, the pump bottle keeps waste to a minimum.

If you have any carbide or carbide-tipped tooling (sawblades, router & CNC bits) and you work with wood, you are no doubt acquainted with the build-up of resin. In the past I have used oven cleaner (bad!) and various citrus based solvents (also bad) to clean my tooling. I tried this Trend spray and I can say it works! Spray it on and you can immediately see the resin begin to dissolve. Spray it on, let it sit for a few minutes, wipe it off. You may have to repeat a few times, but it does take the goop off! I was surprised at how much came of my saw blades! It is very thin...like water...not at foamy or bubbly spray...so it runs off quickly. No bad smell. Won't hurt your hands or the tools...no rinsing needed! Yay! 4 stars for cleaning ability, and an extra star because it's safe and no rinse! Highly recommended.

Reinigung der Sägeblätter funktioniert damit einwandfrei. Beim Auftrag/Anwendung bekommt man nach einigen Malen das Gefühl für die erforderliche Menge des Reinigers. Das reine abziehen mit einem Tuch hat bei mir jedoch nicht sofort zum besten Ergebnis geführt, ich habe eine Bürste dafür genutzt.